AGD Pump kit/body rub?

[Ando]

Like what that guy said above me. You can shim it. Just place a washer between the rail and pump, wrench it down and you should be fine. I did the same to one of my kits. As for the pump rod. Head over to a hobby store, they sell brass and steel rods that will work. Ace sells them too.

[rukh013]

Lowe's sells steel rod as well... you should go titanium or something sexy like that check online, i know i found stainless or titanium when i was anodizing out of my garage

[Ando]

Lowe's sells steel rod as well... you should go titanium or something sexy like that check online, i know i found stainless or titanium when i was anodizing out of my garage

Not the proper size though. they only sell 1/8. It's smaller then that.

[OPBN]

Not the proper size though. they only sell 1/8. It's smaller then that.

I'm assuming I can just use a caliper on an XM15 rod and it should be the same right?

[Spider-TW]

Is the handle delrin? Could you sand the handle down a little to clear up the interference?

[OPBN]

Is the handle delrin? Could you sand the handle down a little to clear up the interference?

Its aluminum. And I think I have it cleared up. Kind of on to making the pump rod.