My board's firing mode resets everytime I turn it off. Is that normal? For example, I turn it on while hold trigger, press trigger twice and set to burst mode. I turn off board and back on, back to firing at semi-auto.
My board's firing mode resets everytime I turn it off. Is that normal? For example, I turn it on while hold trigger, press trigger twice and set to burst mode. I turn off board and back on, back to firing at semi-auto.
The dip switches are on off (down) when I go to programming. Should I put one or both of them back up, and then turn off the board?
Both switches need to be off , you cannot program if either are on , up down , I don't remember
when you pull the trigger twice that puts you in the ROF section , the pred's i've had don't have a burst mode ; semi , auto response , full auto ,NXL a bunch of ramping modes ,
Hold , turn on , pull trigger 1 time to get to FM ( will flash current setting ) , pull 1 time for semi , pull 2 times for AR , pull 3 times for FA ( will flash 2 times to indicate new setting taken ) then turn off
Both dip switches need to be off in order to program the board.
What is the version of your board?
Version 5.0 programming is:
(1) Hold trigger in while turning on board. LED will flash once to indicate programming mode.
(2) Release the trigger and then pull the trigger once to enter "Firing mode". LED will flash the number of times representing the firing mode.
1=Semi, 2=Auto Response, 3=Full Auto, 4= Smooth Ramp, 5=Assisted Ramp, 6=Fast Ramp, 7=Triplet shot ramping, 8=PSP1(3 shots then fast ramp), 9=PSP2(3 shots then super fast ramp), 10=PSP3(3 shots then triple shot ramping), 11=NXL, 12=Breakout(Full auto until trigger released then fast ramping), 13=OMFG, 14=NXL Breakout(1st shot Full auto, then 3 shots and full auto after that)
(3) Pull trigger the number of times corresponding to the number of the new firing mode you want. LED will flash 2 times to indicate the setting was saved.
(4) The board will automatically reboot when you change the setting in register 1.
Except for the Automag in front, its usually the man behind the equipment that counts.
I don't know what version it is, but my settings are different than everyone else's. Here are the registers:
Register:
1 Fire mode :
-1 for sniper
-2 for autoresponse
-3 for fully-automatic
-4 for cocker
2 Burst mode:
- Set Number of shots per burst
http://www.zdspb.com/tech/km2board/p...ockmanual.html
Oh boy... you have an original pre-predator morlock. Those can be a giant PITA
Yeah just got it, must be a dud. I will trash it right now.