-
New barrel problems
Just received an ANS phase II 10" barrel brand new. Put new o rings and detent in it, when I put it on the gun it is loose, not the typical little wiggle like my other barrels. Its got about a full mm around the entire barrel.
I already tried tightening up the barrel set screw to the point I could barely get my other barrels on, so I backed it out to not damage it. Is there any other ways you guys have kept barrels snug in the body?
I was thinking a wrap or two of electrical tape but I imagined that could turn into a sticky mess inside the body... any tricks?
Last edited by Cokrkilr; 01-25-2013 at 08:21 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules