Results 1 to 7 of 7

Thread: washer and c clips?

  1. #1
    Join Date
    Oct 2006
    Location
    central coast cali 805
    Posts
    889

    washer and c clips?

    Do they need to go in all after market bodies? Thanks...

  2. #2
    Join Date
    Oct 2004
    Location
    Daniel Island, SC
    Posts
    1,399
    yes if not its like beating your aftermarket body with a hammer on the inside

  3. #3
    Join Date
    Oct 2006
    Location
    central coast cali 805
    Posts
    889
    So do they come pre installed when you order a ule body ...I've got a few and have never put any in

  4. #4
    They do come installed on ULE bodies and Tac bodies as far as I know. I've never seen one without them. Most aftermarket bodies you buy will also have them already included, or they will specify that you need to pick up your own.

  5. #5
    Join Date
    Oct 2006
    Location
    central coast cali 805
    Posts
    889
    so i cant get the darn c clip in...can i just use the washer and let the bolt spring hold it in place?

  6. #6
    Join Date
    Jan 2002
    Location
    Halifax, N.S., Canada
    Posts
    7,369
    Quote Originally Posted by keiko_819 View Post
    so i cant get the darn c clip in...can i just use the washer and let the bolt spring hold it in place?
    Theoretically, that would work. It would be better than nothing. If there was any rebounding of the washer it could cause some minor wear that wouldn't otherwise occur if it was held solidly in place.
    Except for the Automag in front, its usually the man behind the equipment that counts.

  7. #7
    All you need for the c-clip is a set of needle-nose pliers. Pinch the clip with your fingers until the two ends touch, and then grab both ends with the tip of the pliers. Then just lower it in place and let go.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •