Alright guys I have a tac-one with a x-valve. Valve is stock. After I air it up and can get about 20 shots thru it, then it looses pressure to the trigger. I have trippled Checked to make sure air is still going to it. Any suggestions. Thanks
Alright guys I have a tac-one with a x-valve. Valve is stock. After I air it up and can get about 20 shots thru it, then it looses pressure to the trigger. I have trippled Checked to make sure air is still going to it. Any suggestions. Thanks
Sounds like a bolt stick issue due to a carrier that is too tight. Tune your level 10 bolt setup. Remove your powertube shims, and install the largest carrier that does not produce a leak. Always use the same white oring in each carrier that you try. It is the oring that you are adjusting.
Except for the Automag in front, its usually the man behind the equipment that counts.