Results 1 to 3 of 3

Thread: RT rail question.

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. 02-09-2013, 08:43 PM #1
    C_losjoker
    C_losjoker is offline Puro Tico
    Join Date
    May 2008
    Location
    San Jose, CA
    Posts
    1,118

    RT rail question.

    I have a RT rail that the rail holes behind the inlet line going into the rail are capped by what seem like snap buttons. anyone seen this before? Just wondering if it was done home brew, or something factory did on a few.

    Will try to.post pictures later tonight.
    Attached Images Attached Images   
    Last edited by C_losjoker; 02-11-2013 at 01:28 AM.
    Reply With Quote Reply With Quote
  2. 02-11-2013, 02:47 PM #2
    C_losjoker
    C_losjoker is offline Puro Tico
    Join Date
    May 2008
    Location
    San Jose, CA
    Posts
    1,118
    Pictures uploaded
    Reply With Quote Reply With Quote
  3. 02-11-2013, 07:13 PM #3
    athomas
    athomas is offline Of course it works-its AGD
    Join Date
    Jan 2002
    Location
    Halifax, N.S., Canada
    Posts
    8,039
    I suspect they are screwed into the threaded holes, probably using pliers or a similar tool.
    Except for the Automag in front, its usually the man behind the equipment that counts.
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules