Out of pure curiosity, what is the absolute lowest pressure required to allow the ULT to work properly? As in, minimal risk of short stroking.
Thanks all.
Out of pure curiosity, what is the absolute lowest pressure required to allow the ULT to work properly? As in, minimal risk of short stroking.
Thanks all.
Pull pressure?
Return pressure
It varies so much marker to marker there is no way to tell you that, really.
Its not recommended for classic, but some people have success just dropping it in, some dont.
An x valve or any of its variants regulate to 600 psi or so, the classic is around 400 psi...
So if I were to give you a direct answer... 600 psi, thats what it was designed for
Cool. Thank you. It's just a random question that popped in my head. Lol.
A properly working x-valve/RT valve will be switching bottle pressure to the top of the on/off at the point it needs to reset. That puts you at 800 psi at a minimum normally. The chamber pressures don't actually vary that much except with the bolt type, with the level 10 being about 50 or 75 psi higher (it's in here somewhere). Depending on velocity, bolts, paint and barrels, they run between 400-500 psi on the final dump chamber pressure, but a shutoff RT valve - ULT on/off will be sitting at bottle pressure.
My x-valve + ULT stops cycling at around 800psi