Results 1 to 9 of 9

Thread: after some advice please.

Hybrid View

  1. #1
    Join Date
    Sep 2012
    Location
    Leeds England
    Posts
    10

    after some advice please.

    Got this emag. Valve number is xt00270. It's not on the we are the lucky ones list. So is another one to add.



    Works lovely. But is looking a lot used and abused. Really needs re-anno. Foamy has come out. Is it glued in or does it have a nipple to hold it in place?

    Also i would like to know what I could sell if for in this condition and also if I get it re-annoed.

    Plus i would like to know if it be sacrilege to get it milled and make it unique?

    Thanks in advance

    Mick

  2. #2
    That is an euro xmag, yes you will be hunted down for millling it. not sure on price but I don't think you would make much more if you ano it.

  3. #3
    Join Date
    Jul 2008
    Location
    Massachusetts
    Posts
    551
    +1 On the X-mag, seems going rate is in the 800 category. I wouldn't bother re-annoing it unless you know it's never been done before- Every time it's done the tollerances get a bit more off from the last time. Your foamie glues in and replacements can be had from www.tunamart.com and www.airgundesignsusa.com

  4. #4
    Join Date
    Jan 2002
    Location
    southern IL
    Posts
    1,805
    If you like the gun and just want to add flair. Get it milled and anno to your liking. If you plan to sell. Don't waste your time. It won't add much to resale and will cost to have it done.

  5. #5
    Join Date
    Sep 2012
    Location
    Leeds England
    Posts
    10
    Thanks for the info guys. I have the foamie so will just glue back in. Main reason for anno is due to pic below. But will just leave it and put it up as is tonight after reading rules.


  6. #6
    Join Date
    Mar 2002
    Location
    VA
    Posts
    2,249
    tricky: I went ahead and updated the list for you Lately, I seen euro xmags sell between $650-$1000. Depending on condition and extras. Unfortunately, yours is a little beat up. If you need the money, I would sell it as is. If you like what you got, you could get it reanodized. I doubt you will get your money out of it though if you decided to anodizing and resell it in this market.

    I think milling is okay, only if you can get it milled professionally. Please don't take a dremel to it I think the worst part would be to part out the valve from the Xmag.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •