I bought a pnuemag a couple of years ago which came with I'm guessing a modified sear. So I built an egomag and stole the sear from the pnuemag now I need another similar sear to put back in the pnuemag. Anyone have any idea where I can get some thing like this or will I have to do some cutting and welding on a regular sear? The sear on the top is what I need, the tail that comes down is set back an inch or so.
Usually its taking a regular sear and just taking the arm off.
Originally Posted by flood152
If you need one I have couple of them without the arm already.
That sear looks pretty rough. The hole looks too small as well. Sure that's even a legit AGD sear?
No I'm not sure that it's an AGD sear, but it works perfectly for the job.
Originally Posted by OPBN
at first i thought it was an emag sear, the "arm post" on the emag/xmag sears is directly below the sear pin
but this might have been an old blocky classic sear cut down
i need a sear arm to go back to stock if anyone has one
Last edited by rukh013; 03-18-2013 at 08:52 AM.