I have an opportunity to purchase some AM/MM rail extrusion that was made to AGD spec.
So would there be any interest in a RTPro length rail of this type?
I don't have any specific styles in mind but I'm completely open to a new rail design or perhaps a few.
Of course current designs can be incorporated into the longer length.
I would really like to do a preorder in a large enough number that I could pass a good deal to those willing to prepay.
I want to finish the LPRFG before we start any machining on these but I wanted to get a discussion started now so we can knock these out when the time comes.
LMK what you would like to see.
Here is a concept drawing of an AM Rail at about 9.1" long.
(Stock rails are 8.0" long)