Results 1 to 5 of 5

Thread: Simple X-mag Question

  1. #1

    Simple X-mag Question

    Is the feedneck threaded into the stock block or pressed?

    I removed the set screws (one AM and one MM..)

    figuring if its threaded has a wee bit O'loctite. warmed her up with hot water...hammering.gif

    argh.gif

    no gots..


    Help?!

  2. #2
    Join Date
    Oct 2001
    Location
    Maine, New York
    Posts
    1,169
    It is pressed in for sure.

  3. #3
    Join Date
    Sep 2005
    Location
    Charleston SC
    Posts
    1,185
    To my knowledge, all Xmag breeches are pressed in.

  4. #4
    What set screws, only automag that I can think of with set screws is the micromag?

  5. #5
    Join Date
    Oct 2001
    Location
    Maine, New York
    Posts
    1,169
    Quote Originally Posted by C_losjoker View Post
    What set screws, only automag that I can think of with set screws is the micromag?
    The x-mag modules have two set screws that clamp down on the feedneck for extra insurance. They cannot be seen unless you remove the module and look just above the breach hole (one on each side).

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •