Simple X-mag Question
Is the feedneck threaded into the stock block or pressed?
I removed the set screws (one AM and one MM..)
figuring if its threaded has a wee bit O'loctite. warmed her up with hot water...hammering.gif
It is pressed in for sure.
To my knowledge, all Xmag breeches are pressed in.
What set screws, only automag that I can think of with set screws is the micromag?
The x-mag modules have two set screws that clamp down on the feedneck for extra insurance. They cannot be seen unless you remove the module and look just above the breach hole (one on each side).
Originally Posted by C_losjoker