Results 1 to 5 of 5

Thread: Simple X-mag Question

  1. 05-10-2013, 01:10 PM #1
    neogp
    neogp is offline Registered User
    Join Date
    Feb 2013
    Posts
    15

    Simple X-mag Question

    Is the feedneck threaded into the stock block or pressed?

    I removed the set screws (one AM and one MM..)

    figuring if its threaded has a wee bit O'loctite. warmed her up with hot water...Name: hammering.gif Views: 154 Size: 2.2 KB

    Name: argh.gif Views: 145 Size: 8.7 KB

    no gots..


    Help?!
    Reply With Quote Reply With Quote
  2. 05-10-2013, 01:26 PM #2
    splat15k's Avatar
    splat15k
    splat15k is offline The Beast from the East
    Join Date
    Oct 2001
    Location
    Maine, New York
    Posts
    1,227
    It is pressed in for sure.
    My AO Feedback
    Reply With Quote Reply With Quote
  3. 05-10-2013, 03:31 PM #3
    Dark Side
    Dark Side is offline RPG Fan Club President
    Join Date
    Sep 2005
    Location
    [Redacted]
    Posts
    1,215
    To my knowledge, all Xmag breeches are pressed in.
    Reply With Quote Reply With Quote
  4. 05-10-2013, 10:14 PM #4
    C_losjoker
    C_losjoker is offline Puro Tico
    Join Date
    May 2008
    Location
    San Jose, CA
    Posts
    1,118
    What set screws, only automag that I can think of with set screws is the micromag?
    Reply With Quote Reply With Quote
  5. 05-10-2013, 10:38 PM #5
    splat15k's Avatar
    splat15k
    splat15k is offline The Beast from the East
    Join Date
    Oct 2001
    Location
    Maine, New York
    Posts
    1,227
    Quote Originally Posted by C_losjoker View Post
    What set screws, only automag that I can think of with set screws is the micromag?
    The x-mag modules have two set screws that clamp down on the feedneck for extra insurance. They cannot be seen unless you remove the module and look just above the breach hole (one on each side).
    Reply With Quote Reply With Quote
« Previous Thread | Next Thread »

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •  

Forum Rules