Is the feedneck threaded into the stock block or pressed?
I removed the set screws (one AM and one MM..)
figuring if its threaded has a wee bit O'loctite. warmed her up with hot water...
no gots..
Help?!
Is the feedneck threaded into the stock block or pressed?
I removed the set screws (one AM and one MM..)
figuring if its threaded has a wee bit O'loctite. warmed her up with hot water...
no gots..
Help?!
It is pressed in for sure.
To my knowledge, all Xmag breeches are pressed in.
What set screws, only automag that I can think of with set screws is the micromag?