This is the best I can do with the time I have available.
1. Measure the following:
A to B. From center of rear field strip screw hole to bolt spring seat (without washer).
A to C. From center of rear field strip screw hole to aft edge of breech piece.
A to D. From center of rear field strip screw hole to aft edge of feed tube.
Attachment 88123
Locations in schematic are approximate.
2. Place two balls in the feed tube (positioned vertically) without a hopper. Shoot the bottom one, and report what the top ball does (flies out of feed tube, feeds properly, jostles a bit, etc.). Try to quantify if possible. For example, it flew 2 feet out of the feed tube.
Last edited by nak81783; 08-07-2013 at 07:15 PM.
Last of the Salzburg Clan
Reply With Quote