Hey guys, my hopper is too wide for my ULE feedneck. and the feedneck doesnt seem to want to come apart. Is locktite what is stopping me from getting it off?
Thanks,
Trigger
Hey guys, my hopper is too wide for my ULE feedneck. and the feedneck doesnt seem to want to come apart. Is locktite what is stopping me from getting it off?
Thanks,
Trigger
Try heat and a strap wrench, that should do the trick. I believe there is some sort of loctite on there.
Heat will break the loctite bond. The temperature is higher than the 100 degrees Celsius boiling can reach, so you will have to use a torch or an oven.
Except for the Automag in front, its usually the man behind the equipment that counts.
Thanks, I have a torch. Will be trying tomorrow.
My Rotor feedneck was also too thick for the ULE feedneck. When I removed the feedneck from my ULE body, I did it with an adjustable wrench. I marred the feedneck a bit, but knew it was going to happen prior to doing so. Never planned on using the he stock ULE feedneck anyways. Slapped a CCM NoPro on my ULE, and couldn't be any happier.