ULE Feedneck Removal

[steve_81]

What is the best/easiest way you guys have found to remove the stock freedneck from a ULE body?

Also will THIS feedneck work on the ULE body?

Thanks!

[OPBN]

Strap wrench. If loctited you can try boiling it for a bit to loosen it up. If that doesn't work you can always try a pair of pliers. To be quite honest the stock feednecks are worthless so messing them up isn't a big deal. If you really have a tough time with it you can drill a hole all the way through and use a screw driver through the holes to twist it out.

Yes that feedneck will work.

[steve_81]

Awesome! Thank you.

[athomas]

Quite often, boiling can't get the temperature high enough to break the Loctite bond. You'll need an oven. Then use a strap wrench to turn it out.

[Justus]

Just like a strap wrench, a heat gun is a relatively inexpensive tool that everyone should own. I think they're either $10 or $12 from Harbor Freight. That gets the job done in a few seconds.

[OPBN]

Just like a strap wrench, a heat gun is a relatively inexpensive tool that everyone should own. I think they're either $10 or $12 from Harbor Freight. That gets the job done in a few seconds.

While I agree to a degree, why spend $20-30 on strap wrenches and heat guns to remove a.. and I'm being generous $5 part? Drill a hole in it, wrench it off or whatever and throw it away.

[knownothingmags]

i always use my hands,
with a little help from show mechanix gloves and a strip of rubber backed shop carpet.gives no slip and comes right off.
i hold the feedneck wraped in carpet rubber and my hand, then i stick a nylon or wood dowel rod through the body and start twisting.

takes a few tries, but i have yet to come across a stock ule feedneck that i couldnt take off, and i have come across alot of bodies.
*no damage, and anyone who has meet me wich are few, im am by no means a gorilla of strength.