So are factory RTP and Emag rails obsolete?

[luke]

Looks like I'm stuck and going to have to do a run of Emag style rails, would anyone be interested in this style rail, no site mount holes or jewel recess.
All my current style rails would be available. Plus I'm going to include a Shadow style design.

This would NOT be a preorder offer, but I could offer a discount if you were will to prepay. It just helps me figure out which style rail to machine.

LMK what you guys think, whatever the case I owe a customer a rail so I need to get them done asap.

PLEASE SEE POST #42

[El Zilcho]

I need a warp right pump milled ULE emag length rail (if possible) and could use a ULE emag length rail also. The short answer is yes x 2.

[robertreed711]

Depending on price I could be interested on a shadow style rail.

[tbaggin]

id be in for a shadow style rail esp if it can be pump milled. Im using a RM kit, would it be AM length

I can pre pay as well.

[luke]

Pump milling takes quite a bit of room. It could be flat sided like the shadow but it wouldn't slim.

[luke]

I'm not sure how deep I can go on discounts if it is over and above my current programs. Besides the manufacturing of the rails my current programs are ready to run. So, extra programming, design and machining set ups that are above a standard run would be subject to extra charges. I dont really know where that will end up, we'll just have to play it as it unfolds.

[keiko_819]

id be in for a shadow style rail esp if it can be pump milled. Im using a RM kit, would it be AM length

I can pre pay as well.

+ 1 for this
shadow style, pump milled, and am length...

[luke]

+ 1 for this shadow style, pump milled, and am length...

We can do that, it's even easier if more people want it.