-
Classic Mag feedneck trimming methods?
I have a couple bodies that have been trimmed down by previous owners and wanting to do the same to a couple more...looking for a nice clean cut.
Any advice on methods?...or is this just a hackey hack saw kinda job?
One of the bodies I have has circular grooves on the neck below where it was trimmed...perhaps from hand held pipe cutter....? I have a standard feed body that was powder coated many years ago and would like to cut it down without destroying the finish on the rest of the body(feedneck doesn't matter).
Also curious if power feed right bodies are hard to find?
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules