Results 1 to 12 of 12

Thread: Velocity problems

Hybrid View

  1. #1
    Join Date
    Dec 2007
    Location
    Spokane, WA
    Posts
    225

    Velocity problems

    I am working on my friends mag it has a xvalve with level 10. with the gold spring with it turned all the way up it shoots around 225 with the red spring the best I can get it to is 265 and it wont shoot with the silver spring. because I have never had a velocity problem with a mag this is a new problem for me does anyone have any other suggestions, the valve and all orings look to ge in great shape, almost like new.

  2. #2
    When you say turned up all the way you mean as far as it goes without venting from the rear right? I've seen this twice.
    Case a) Needed new reg-piston assembly
    Case b) Tank output was in the 550 range (should be 800 minimum with LX/RT)

  3. #3
    Join Date
    Dec 2007
    Location
    Spokane, WA
    Posts
    225
    Yes all the way in and not venting, not the tank it is a 1100psi out put tank, and I can try the reg piston.

  4. #4
    Join Date
    Feb 2011
    Location
    PHX, AZ
    Posts
    1,440
    what set up are you running? how much air is in tha tank being used? does tha valve have velocity problems when used on a different mag?

  5. #5
    Join Date
    Dec 2007
    Location
    Spokane, WA
    Posts
    225
    ptp micro emag does the same in e and mech mode, 1500psi or better every time I have tested it, and I was going to try switching valves but first I have to adjust the level 10 in the other valve before I try that.
    Last edited by Sniper Steve; 10-06-2013 at 04:51 PM.

  6. #6
    Join Date
    Dec 2007
    Location
    Spokane, WA
    Posts
    225
    Ok I have tried the valve in another gun and it works fine and I have tried a different valve in the gun and it is shooting low. so it appears to be the gun, how can I change the gun to fix that problem?

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •