Registered User
Ok, can someone please tell me why my minimag is blowing air out the front/barrel, please?
It was leaking out the reg (bad reg piston o-ring). I replaced the o-ring and dry fired it twice and then it started blowing air out the front of it like crazy.
and the worst thing about it is when I pull the trigger and hold it, it stops! then when I let the trigger go, it just goes back to gushing air out the front
smh.... any thoughts on how I can fix this? This is my first AGD.
Nobody's Perfect
within the powertube(where the brass tip is, which the bolt slides on & over), there is an oring. replace that and leak will stop.
Of course it works-its AGD
Replacing the powertube oring usually fixes this problem. If it doesn't, the powertube spacer may be too long. Install a shorter spacer to get a tighter seal against the back of the bolt stem.
Except for the Automag in front, its usually the man behind the equipment that counts.
Posting Permissions
Reply With Quote