WTS mini mag and parts mag
I have a pair of mags that have been sitting unused on my workbench for a long while and since I'm in need of some holiday cash I figure now is a good time to give them new homes.
First is a minimag
I have not aired this up since it was last played with at Living Legends 5, which was a couple years ago, and with my HPA tanks depleted I cannot test it out. Thus I will sell it as is. *see note below
price drop to $120 /obo shipped (US priority)
Next is a lot of tac1-ish parts.
The reason this isn't an entire gun is that the rail's barrel pin won't allow the body to fit flush, but I really don't need the grip or the valve, bolt, barrel etc... so I'd like it to all go together.
Asking $220/obo shipped (US priority)
Please email with questions or offers, mostly interested in $.
Thanks for looking
Last edited by Scrapiron; 12-15-2013 at 04:39 PM.
Reason: price drop
You realize all you have to do to get the Tac body to fit on the rail is to remove the twist lock pin from the rail right? Use a bench vise and some wood blocks and press it out.
If i intended to invest any time into it sure, i would do that. I'm pretty close to selling off all of my remaining gear anyway.
dropped the price a bit on the mini mag. I was going through and taking an inventory of my gear to sell and I came across my old PMI 72/3k tank that still had a little over 1k psi in it, so I tried the mini mag and it did some down the barrel leaking, likely due to a bad on/off ring, hence the drop in its price.
PM me who did you get the mini mag body from? Is it paint, like airbrush?
I went sifting through old PMs here and on MCB, pretty sure the minimag came from a user on MCarterbrown called "Tedaut".
The finish is paint but its definitely not rattle-can its more like automotive paint.