-
WTS mini mag and parts mag
I have a pair of mags that have been sitting unused on my workbench for a long while and since I'm in need of some holiday cash I figure now is a good time to give them new homes.
First is a minimag
I have not aired this up since it was last played with at Living Legends 5, which was a couple years ago, and with my HPA tanks depleted I cannot test it out. Thus I will sell it as is. *see note below
Asking $160.00/
price drop to $120 /obo shipped (US priority)
Next is a lot of tac1-ish parts.
The reason this isn't an entire gun is that the rail's barrel pin won't allow the body to fit flush, but I really don't need the grip or the valve, bolt, barrel etc... so I'd like it to all go together.
Asking $220/obo shipped (US priority)
Please email with questions or offers, mostly interested in $.
Thanks for looking
Last edited by Scrapiron; 12-15-2013 at 04:39 PM.
Reason: price drop
-
You realize all you have to do to get the Tac body to fit on the rail is to remove the twist lock pin from the rail right? Use a bench vise and some wood blocks and press it out.
-
If i intended to invest any time into it sure, i would do that. I'm pretty close to selling off all of my remaining gear anyway.
-
-
-
dropped the price a bit on the mini mag. I was going through and taking an inventory of my gear to sell and I came across my old PMI 72/3k tank that still had a little over 1k psi in it, so I tried the mini mag and it did some down the barrel leaking, likely due to a bad on/off ring, hence the drop in its price.
-
PM me who did you get the mini mag body from? Is it paint, like airbrush?
-
PMing
I went sifting through old PMs here and on MCB, pretty sure the minimag came from a user on MCarterbrown called "Tedaut".
The finish is paint but its definitely not rattle-can its more like automotive paint.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules