So I have this LvL 7 bolt (I think) and it is slightly short enough for a paintball to roll back in the breech.
would it be possible or plausible to machine a groove for a MINI/AXE rubber tip to attach???
i imagine that it would make the bolt "easier" on paint as well as solving the rollback issue. If that is the case could this be done to other bolts as well?
Would it make any difference at all?
the mini bolt is loosely similar in design to an automag bolt
just a thought
"always reaching for the next big thing"
well here is a good thread about foamie vs no foamie
thats basically what that rubber tip is….another type of foamie.
yes but my problem is my current bolt is to short
Originally Posted by need4reebs
there are dozens of new body ideas thrown around (a few by me) when's the last time someone improved on the bolt?
wasn't there a venom bolt???
Originally Posted by rukh013
maybe try a longer foamie?
not sure when tha last time was for improving tha bolt? but yeah there was a venom bolt…but not too sure if that was an improvement?
Are you using the RT/E-Mag bumper or the classic bumper? The classic is a bit thicker and may solve your roll back issue.
Oh the toxic bolt. Ans had there own design too. Not really any better though. It did wear out quicker. Softer material I would imagine.
what became of the RPG bolt???
anyone have a lathe? i have the sacrificial parts...