Not sure I have ever seen someone try this before,... wanted to do it for some time.
Tapped out a Level 10 bolt and bored a foamie to accept a screw.
Im going to test this in a few bolts over a season with the following setup:
Bolt #1 - foamie and screw only (no loc-tite on screw or adhesive on back of foamie to face of bolt)
Bolt #2 - foamie and screw with loc-tite on screw only (no adhesive on back of foamie to face of bolt)
Bolt #3 - foamie and screw with loc-tite on screw and adhesive on back of foamie to face of bolt
Idea is: to have a way of instantly replacing a foamie at the field without waiting for an adhesive to cure
Open to suggestions, ideas, concerns, and comments.
Discuss!