Hey guys,

I have a couple of E-LCD Mag frames. The LCD screens work. The trigger switches work, and the solenoid works.

HOWEVER, the solenoid does not seem strong enough to cause the sear to trip. I HAVE A BRAND NEW BATTERY TOO. It's the same on both frames.

With the frame off, I can press against the solenoid plunger with an allen wrench and pull the trigger to watch the plunger push against the wrench. It doesn't seem strong enough to handle the pressure the on/off pin is applying to the sear. This is with a Classic valve running CA.

Were the solenoids just weak? Were they regularly replaced? Is there an easy fix? Should I send it to Luke?

Any response is appreciated