Last edited by AO Moderation Team; 02-25-2014 at 06:03 PM. Reason: tags
Weren't we supposed to have some assembled pics from bigevil at some point?
Thats very cool to be able to print your cad file to make the prototype.
Yes, Ive had some delays. But I believe I forgot to adjust something in the prototype. Been messing with it. Still going to send it to BE. But think I need to run thru one more prototype.
Last edited by cougar20th; Today at 12:24 PM.
The one on the left looks awesome, the one on the right might be good too.
If ordering logistics and cost allow, I'd probably order a couple
Obviously not an issue for plastic triggers but for the metal ones, have you considered the possibility of increasing the trigger pivot OD to allow purchasers to add a thin wall delrin (or similar) bushing in there without the wall getting creepy?
The one on the right is for the Demon frame.
Theres no need for a delrin bushing. These pivot just fine when made of aluminum.
The one on the left was a surprise, it looks a LOT like one I'm currently carving out for a pneumag. Yours is a bit deeper fore-aft than the one I'm making, wider too I think, mine is only 1/4"
The plastic isn't so much for friction as for feel... Not sure how to describe it. No big deal in any case thanks for the reply