Hey guys, how goes it? I was told by a mutual AO member/friend that the best way to get ahold of Tom would be posting a thread here. I was hoping to get in touch with him to discuss a question I had for mr kaye. Hope this works, Thank ya much!
Hey guys, how goes it? I was told by a mutual AO member/friend that the best way to get ahold of Tom would be posting a thread here. I was hoping to get in touch with him to discuss a question I had for mr kaye. Hope this works, Thank ya much!
Postvthe question. ..
I have one.. I purchased a mag off craigslist. It does not have the stock regulator on the rear.. How would I find out if it's a level10? He said he purchased in 99 . I assume it does
pictures would help
level 10 is the bolt not the back half of the regulator.
Correct the back of the valve is a regulator if it is not stock it should be aluminum most likely made by hurricane labs iirc. The easiest way to tell a level 10 bolt is to take the bolt off the valve if the valve tip has a slot its probably not level 10 if it is a hex it most likely is a level 10. Also look at the bolt stem from the back of the bolt. If it is solid its level 7 if it is hollow it is level 10.
Sure you can print up some stuff your your guys. Glad to have them on board! The other posters are right, LVL10 is the bolt not the back.
AGD
Looks like I'll be sporting a new shirt or two... may I add; I've been shooting mags for over a decade and could say I've converted many people to them, matter of fact, just fixed a local guys mag that has been sitting for years and he just purchased a nice ule mag in the BST section...I can easily say that the bug bit pretty hard around here...
I'll buy one