$15 Each
Design #1
Design #2
Design #3
Design #4
$15 Each
Design #1
Design #2
Design #3
Design #4
Last edited by luke; 03-01-2014 at 01:26 PM.
Ohh want!
Can you do a #2 without the two holes? Pretty much a billet replacement of a stock lever. Could use one for my xmag.
I'll have to check to see if I have any materials, I cut up everything on this run. I might have some scrap in my recycle bins that will suit the bill, how many did you want?
Got them in today. Very nice. Now I just have to find something to put them on.
No problem, the machine was still set up.
No doubt, I think I've only done it once since 2001, that was a PTP body.seams really weird to be buying custom machined stuff off of AO!
Thanks, but I've still got SO MUCH to learn, hope I get a passing grade.You do some very nice work
Not sure how I missed this, thanks for the pictures.
I hope you liked what you saw !
Looks good.