Results 1 to 9 of 9

Thread: Refinishing mag valve body.

Hybrid View

Previous Post Previous Post   Next Post Next Post
  1. #1

    Refinishing mag valve body.

    I have an older valve body and was thinking about having it cerakoted to match the rest of my mag. Was wondering if this would cause an alignment issue, due to the increased diameter thickness. What do you all think?

  2. #2
    Join Date
    Jan 2002
    Location
    Halifax, N.S., Canada
    Posts
    8,039
    Yes it could. Tape your body and place it on the rail. While it is on the rail cut away all exposed tape. Then remove your body from the rail and you should have a masked off body that you can paint. The masked off area will allow the unpainted body section to sit on the rail without affecting the tolerances. You will only be able to see the painted body sections above the rail, so it will look completely painted.
    Except for the Automag in front, its usually the man behind the equipment that counts.

  3. #3
    I will see if that is something they can do, I am not sure about the entire process.

  4. #4
    Finally got to talk to the shop that I want to do my valve. They assure me that the finish will not be any thicker than a sheet of notebook paper. And if need be they can do masking . I hope to have the project wrapped up In the next couple of weeks, still have to finish design and machining on my pump parts.

  5. #5
    Join Date
    Jan 2002
    Location
    Halifax, N.S., Canada
    Posts
    8,039
    The paint thickness becomes twice the distance. The distance is increased by that amount at the front of the sear and that amount at the back of the sear. It means that the on-off pin will be affected by twice the thickness of the coating.

  6. #6
    Cerakote is applied at less than 1mil. Which means at most you would have a 2mil addition in thickness to your valve (.002") depending on the tolerances your rail was machined with it will likely be fine. I do this every day and I have not had an issue. If you are worried though mask anywhere the valve will touch another piece of metal. Peal the mask off and it will fit as normal leaving only visible areas coated
    PM ME FOR CUSTOM POWDER COATING
    Like Us On Facebook

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •