Burst mode?

[Woodsman]

Greetings fellow Automag shooters, I’m new to the forum but not paintball. I’ve looked in on this page in the past but never joined because I thought I knew all that I needed to know about this MAGnificent weapon. Granted the mechanical operation of the Automag is flawless, but the “burst” modes are a mystery to me. First how do I activate them? Second; are the shots per second limited in burst mode?

Any help would be greatly appreciated...

[Cyco-Dude]

here is the emag manual. the burst modes are activated by a jumper you plug onto the board, and the bps is capped by what you set it at.

[PsychoJester]

I would like to see an close up picture of the jumper please

[Cyco-Dude]

this is the part.

[athomas]

I am assuming you have AGD firware version 1.37. You must install the mode jumper to activate burst mode. Once the mode jumper is installed, all features are enabled, including burst mode. If you select burst mode, the rate of fire is limited to 9bps.

If you install the later versions of firmware or the aftermarket Xmod, then many other modes are available. Xmod allows ramping as well.

[Woodsman]

Sorry for the low resolution but the red pixels are murder on the lens of my phone! Anyway it says AGD 3.2

[Woodsman]

Hey guys, thanks for the quick response! I posted some pix of the internals and I hope you can see them..

[Woodsman]

[Woodsman]

I'm guessing it's the little brown loop in the center of the frame?