should I melt the revy to go around the warp feed hose or should I cut a hole in the revy and run the hose thru it.
should I melt the revy to go around the warp feed hose or should I cut a hole in the revy and run the hose thru it.
Cut or melt a hole.
I melted one and didn't like it. The other side is now a spare part.
It's cleaner with a hole. Heat up a knife to cut the hole its easier then a dremmel
I bet a forstner drill bit would do magic for that.
I would use a hole saw...
Keep the blimp on top. Why add more weight to an already heavy gun...
Quiet Sally, your noodle arms are a testament to you lack of knowledge and absence from the way of the warp.
A hole saw and dremel are your friend in this case. I recommend only drilling one side of the shell. Allows for super tight setup. I guess doing half and half might allow bringing it even closer , but then thumb clearance becomes an issue.
Warp Feed Evangelist
My Feedback