Z-Mag - MOVED
I'm getting a pneu'd z-frame and building up a new mag around it. Thus, I need to shed the old.
The z-frame is unmolested apart from being drilled and tapped for Luke's panels.
The rail has the rearmost hole drilled to accept a sling point.
Luke's short, straight foregrip extension has been milled slightly to sit flush with the z-frame.
The direct feed body has the feedneck chopped so a feedneck elbow sits down on the body.
The marker will come assembled as shown without a valve or thumbscrew.
It has the twistlock assembly, sear pin, and sear.
changing this to a misc thread parting the z-frame.
Last edited by bowcycle; 07-05-2014 at 08:27 PM.
I'm changing this.
I'm moving the z-frame to a misc thread and keeping the rest.
Last edited by bowcycle; 07-05-2014 at 08:25 PM.