Results 1 to 4 of 4

Thread: Z-Mag - MOVED

  1. #1
    Join Date
    Apr 2012
    Posts
    404

    Z-Mag - MOVED

    I'm getting a pneu'd z-frame and building up a new mag around it. Thus, I need to shed the old.

    The z-frame is unmolested apart from being drilled and tapped for Luke's panels.
    The rail has the rearmost hole drilled to accept a sling point.
    Luke's short, straight foregrip extension has been milled slightly to sit flush with the z-frame.
    The direct feed body has the feedneck chopped so a feedneck elbow sits down on the body.

    The marker will come assembled as shown without a valve or thumbscrew.
    It has the twistlock assembly, sear pin, and sear.

    changing this to a misc thread parting the z-frame.



    Last edited by bowcycle; 07-05-2014 at 08:27 PM.

  2. #2
    Join Date
    Aug 2008
    Posts
    699
    Pm'd

  3. #3
    Join Date
    Apr 2012
    Posts
    404
    replied.

  4. #4
    Join Date
    Apr 2012
    Posts
    404
    I'm changing this.
    I'm moving the z-frame to a misc thread and keeping the rest.
    Last edited by bowcycle; 07-05-2014 at 08:25 PM.

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •