-
pneumag classic help
Hey everyone, I just installed a pneumag frame on my classic. Now, i am assuming that the pneumag frame is working, and the classic was working before hand...
I started by installing an rt on/ff, then the complete frame swap....
Pulled the bit off the sear that you dont need....
when i pull the trigger, the pneuframe works, but it doesn't trip the on off at all... any ideas?
Should i not have the two the orings in the on off that were there with the classic on off?
do i need a different sear?
Tested it with the classic on off too... No change. Is it lvl 10 related?
thanks!
Last edited by ascent; 07-26-2014 at 01:33 PM.
Posting Permissions
- You may not post new threads
- You may not post replies
- You may not post attachments
- You may not edit your posts
-
Forum Rules