warp feed problems

[vintage]

having trouble getting one timed to my e mag, it won't pick up the recoil most of the time in mech mode. in e or hybrid mode it works fine on 9v but in 12 it runs all the time.

[Cyco-Dude]

is the warp feed plugged into the emag board?

[OneSelfLost]

Have you tried to take the back plate off and turn the sensitivity down until it stops spinning?

[vintage]

is the warp feed plugged into the emag board?

yes

[vintage]

Have you tried to take the back plate off and turn the sensitivity down until it stops spinning?

yes

[Tunaman]

The 12/18 volt mod uses 100 uf capacitors. Check to see if they are installed on both sides of the regulator.