im about to get my restock of emag batteries in,
I was wondering if anyone is interested in me stocking pneu kits, ones with the msv2 and the mpa-3 ram.
let me know your thoughts.
thank you,
KNM
im about to get my restock of emag batteries in,
I was wondering if anyone is interested in me stocking pneu kits, ones with the msv2 and the mpa-3 ram.
let me know your thoughts.
thank you,
KNM
Last edited by knownothingmags; 12-02-2015 at 05:13 PM.
or am I stepping on mag79's toes.
I didn't know if he is around offering the kits.
Get them and put them out. Mag79 is very sporadic in his time here, from what i seen. I know, i want a kit, just to have.
its would be the msv2, mpa3 ram, barb fittings, trigger rod, lp hose and mounting screws and trigger stops if I can get them.
and the magnet mod if people want it.
all parts ordered minus set screws and trigger rod but those will get here before anything else even if I order them later.
ill throw up a dealer thread when I get the parts in hand.
what length set screw for trigger stop screws with nylon tip do people use?
Last edited by knownothingmags; 11-11-2015 at 11:18 AM.
I use 6-32 and I've seen others use 8-32.
Length depends on the trigger but 1/4' is a good average.
parts ordered.
now just need to wait for them.
I almost have all the parts in to make the pneu kits
magnet mods ready (if you feel you need them that is )
I assume you're gluing the mag mod on? I've always wondered if mounting the side near the valve through the mounting holes would be better than gluing it to the top? Meaning provide the mount to utilize the screw holes. Not sure if I'm explaining myself well?
if I have time ill make some that utilize one of the mounting holes.
but I will be using epoxy
just like all the guys have done in the past.
as long as you don't go torking on the parts they tend to stay in place.
__________________________________________________ ___________
ill kick the design to utilize the mounting hole in the msv 2 tomorrow,
this will allow for no epoxy
Last edited by knownothingmags; 11-22-2015 at 07:13 PM.
like this?
Yep......exactly. I'd be interested in a couple of those mounts that don't need epoxy and utilize the mounting holes.
With the correct materials you could print a new MPA-3 ram, combining the piston/oring carrier and ram in one part.
yeah I know right,
I have all of the materials in my office to do it.
just need to get a printer back in my hands lol
and to do some real testing.
I want to make a setup and bring it to tunaball if I can make it.
that would probably be the best testing I could think of, next to handing out free samples, and not getting feedback.
Last edited by knownothingmags; 11-22-2015 at 10:06 PM.
magnet mods (msv 2 magnet returns) complete
just waiting on getting my msv2s in
with these magnet mods you will have to unscrew the mounting screw and pull it out to adjust the magnet screw.
FINALLY!!!! got my msv 2s in.
ill throw a thread up tonight in dealers section detailing the kits that will be offered.
Have you posted this in the AGD pages on facebook?
I have some in stock so you are stepping on MY toes!
......You know you want one!!
Are the pneu kits hard to install yourself? Keep in mind I have a y frame intelliframe.