Hi all I'm new to the forum and Automags in general. I recently purchased an eclipse splash mag which has an Xvalve and level 10 bolt fitted but it's definitely not working correctly. Spares for Mags in general in the U.K. Are seemingly a little more difficult to come by however I am aware that there is still a good supply stateside 👍
I now want to get her up and running and while I'm very pleased with the overall condition it does appear to have a few issues,
1) It leaked down the barrel when I first air'd it up and I finally pinned this down to a bad o ring between the power tube and the valve body. (Sorted I think)
2) with the old trigger frame fitted to the marker. It will fire but the bolt seems to stick and while it does shoot abeilt slowly it will not R/T and seems to chuff between shots.
3) I have now purchased an intelliframe and fitted it but now the marker won't shoot at all, which is now my main issue.
I have looked over the existing threads and found a lot about not adjusting the trigger rod (I'm sorry if that's the wrong terminology) but given that it shoots with the standard trigger frame installed I feel that the on/off valve is working correctly and as far as I can see it's almost like the sear is not actually activating the on/off valve at all.
The sear rod upon air up is pushed forward into the trigger as is normal? But it is stiff, stiffer than it is when the standard trigger frame (plastic type with single grip screw that has had the trigger guard cut to accommodate the double trigger)
The sear in the marker has UL stamped on it and as far as I can tell it's compatible with the intelliframe.
I suspect that I need to buy a spacer kit for the bolt to address the 'chuffing' issue but I am stumped with regards to the no shooting issue with the intelliframe.
Any help you guys can offer will be greatfully received.