this is a machine keen community, would it be possible to make say.. a dye rotor with an entirely aluminum shell and feed tube? thanks
this is a machine keen community, would it be possible to make say.. a dye rotor with an entirely aluminum shell and feed tube? thanks
You could probably get one machined. Spendy for sure. You could get one 3d printed in metal. It would cost a bit also
Sent from my SM-G930V using Tapatalk
How well does hydro dip hold up on a hopper?
How deep are your pockets?
lol i was more wondering if it was possible... i dont necessarily want one made... but if i did would it be about 400 bucks?
If I was going to do something nutty like this, I'd go all the way and use Ti sheet.
Sure I'd have to watch out for galvanic issues, but a little marine grade anti seize Would be all your need I think
No. The memories I have of actually liking rainbow Ti anno are to difficult to reconcile with my psyche...