Thanks Allen.
Thanks Allen.
doubtful but, I have a "Luke milled" one available if needed.
I kinda hate to be that guy, but ... any news?
How's the fitting process going?
I'm really looking forward to feeling this and checking out my z-pneu'd marker.
Currently dialing in the trigger geometry on both triggers, should be ready for production soon.
Sounds good. Your triggers have always felt nice.
Thanks.
So it looks like were ready to start production!
Z2P Blade Trigger (Pneumag Only)
Picture shown with safety engaged
Standard Mechanical Blade Trigger
I have some very minor adjustments to make, then I need to setup new machining files for production and were off to the races!
Thanks for everyone's patience on this project.
I'll send out private messages to everyone this weekend to get your final orders dialed in so I can set up invoices.
Thanks
Last edited by luke; 05-22-2018 at 02:36 PM.