Results 1 to 4 of 4

Thread: 4500 Flatline questions

  1. #1
    Join Date
    Jan 2002
    Location
    In Uranus
    Posts
    1,859

    4500 Flatline questions

    Can I put an elbow at the "out put" part of the tank and then the male end Quick D that it comes with? I wanna do this so it has a 90 degree bend up towards the valve.
    I already have a screw in bottle going into screw in on-off. I wanna be able to take the on-off, off the drop, and slide the dove tail of the Flatline on using the same braided hose to the valve. Get it?
    Next question. The drop forward is a Custom Products with a C.P. on-off. Will the dove-tail on the Flatline fit on to the drop forward dove tail? I know it was designed with shocktech in mind?
    WE ARE DEADCELL, AND WE WILL RUN THROUGH YOU

    Dayspring - "We've had Clare at Shatnerball." "I'm confident that she can take 20 guys."

    "I'd trade my cocker for some steady pu**y"

  2. #2
    Join Date
    Oct 2000
    Location
    easthampton, MA 01027
    Posts
    1,524
    yes and yes

    just make sure to drain the tank first when workin on it and then once done and ya get it filled gas up the gun and spray a little soapy water on the new connections you made.... if there are no bubbles, you are good to go....

    pretty much all rails and rail mounts are standred size... i haven't run into any off size ones as of yet
    Virus, King of the Basement Trollz has spoken

  3. #3
    Join Date
    Jan 2002
    Location
    In Uranus
    Posts
    1,859
    Would teflon tape make sense on those threads

  4. #4
    Join Date
    Oct 2000
    Location
    easthampton, MA 01027
    Posts
    1,524
    yup it should be fine....

    just make sure to keep the tape away from the bottom one or two threads (side gettin screwed in first) to keep any unwanted tape debrie from gettin in the way

Similar Threads

  1. Flatline 4500 Servicing
    By SHAG in forum Automags - Tech Forum
    Replies: 2
    Last Post: 09-08-2002, 06:22 PM
  2. where to buy a flatline 4500 tank
    By rudy in forum Paintball Talk
    Replies: 5
    Last Post: 06-13-2002, 01:17 PM
  3. Flatline questions
    By Tubby_Ninja in forum Automags - Tech Forum
    Replies: 1
    Last Post: 01-13-2002, 02:30 AM

Posting Permissions

  • You may not post new threads
  • You may not post replies
  • You may not post attachments
  • You may not edit your posts
  •