I am sure its been posted once before. I just can't seem to find a thread on it. so was wondering if anyone knows the procedure on how to shorten the trigger pull on the Emag. Or if there is a place to download the info. Thanks.
I am sure its been posted once before. I just can't seem to find a thread on it. so was wondering if anyone knows the procedure on how to shorten the trigger pull on the Emag. Or if there is a place to download the info. Thanks.
Well it's all in the video that you should have gotten but here's a link to a WARPIG review of the e-mag that explains it well, too. Scroll about halfway down...http://www.warpig.com/paintball/tech...g/review.shtml
Ahhh! At last a good link to doing that, I was wondering how I was going to go about taking the back travel out of the trigger.
"The BEAST"
"No-Rise" E-mag
Level 10 Bolt
AGD Flatline 91cu in/4500psi
Black HALO B
"Red Heatseeker"
Red to Clear Fade Freak Factory Impulse
68/4500psi Max-Flo
Red HALO B