Roller Trigger specs

[willboy_2]

Yea, i'm looking in to purchasing one of the roller trigger mods. I need to know where it would need to be positioned in my intellaframe blade trigger and what millworker(or airsmith) is qualified to do such a process. Any and all help will be greatly apreciated.

[PurePower]

This doesn't really belong in deep blue but...

The roller should be positioned in the middle of the tigger. It will most likely not work well if at all on an intelliframe. It was designed for electronic guns with very small trigger pulls. To install it 4 holes (or 2 holes that go all the way through the trigger) need to be drilled into the trigger and threaded for the screws (can't remember the size but all of this has been covered in the Roller Trigger threads). Then just put the two small plates over the holes you drilled and screw them on with the supplied screws, pop the roller on and you're good to go.

Search for the threads they will answer all your questions and will have detailed pics of the roller trigger installed.