Re: Micro E Mag won't fire in electronic mode.
Originally posted by ignatz
4. When I attempt to fire the marker in E Mode, the shot counter increments but the solenoid doesn't engage and the Intellifed Warp does not spin.
5. If I move the trigger magnet too far forward, the LED display stops functioning properly (it only displays 10-40% of the dots it should) and once I back it out to a safe distance, the LED display begins working correctly.
You have done an excellent job in providing information for us to help.
4. This is important in figuring the problem. Since the counter is incrementing, it is a good bet that the microprocessor and HES is functioning.
5. I don't know what could cause the LED display to react like this unless there was a power problem.
The combination of both of the above leads me to think that maybe the electronic ground is bad between the board and the body. Try cleaning the hole where the screw goes through the board into the grip frame.
Except for the Automag in front, its usually the man behind the equipment that counts.