Rotor on a Warp Feed... anybody got pictures?

[AGDRetro]

Thinking about build a warped mag, but I was wondering what my Rotor would look like on the Warp Feed, can anybody hook me up with a picture?

[zondo]

Hmm... threw the warp on just to see, granted that mine is a vertfeed, so it would look smoother otherwise.









It was pretty tight, but eventually found a good position for everything.. of course after I took the pictures

I will say that the Rotor feedneck is pretty thick, so you may have to do some combo of sanding and loosening the warp shells.

[pbjunky99]

I have been thinking of this also. I was wondering if the warp can keep up with the Rotor?

[cdc120602]

Zondo, that's sexy!!!

pbjunky - Website says 20+ bps with 12 volt input for the Warp.

[Ando]

I've never tested the max BPS but I've hit 21bps with a modded 12v warp. I think cockerpunk did a youtube vid with him upping the voltage to 18 which in theory would make it go faster. I wouldn't recommended it, don't want anyone to blow their board. He said the board can take it but I've never seen or read anything stating that. I'm sure one of the AGD nerds here can enlighten us.

[Ruler_Mark]

I've never tested the max BPS but I've hit 21bps with a modded 12v warp. I think cockerpunk did a youtube vid with him upping the voltage to 18 which in theory would make it go faster. I wouldn't recommended it, don't want anyone to blow their board. He said the board can take it but I've never seen or read anything stating that. I'm sure one of the AGD nerds here can enlighten us.

I wouldnt doubt it since our valves can handle 3000k psi and normally take 800

[Ando]

Well if someone can show me in black and white that it can hold out at 18v. I'll use one of my warps as a test bed. Just to be on the safe side I'll defiantly make a harness with an adj volt reg and a few diodes to get it at or just under 18v.

Then I'll do a drop test and see what we get, maybe even dial in my emag to 25 bps (or 30 ) and see if it keeps up. I haven't tried my E-mag at 30 yet but this is a good enough excuse if any

I don't see it going any faster then 25 which is more then enough IMO. Hell 15BPS is fast enough

[Ruler_Mark]

ando you may have to shave your on off pin to get past 20 in your emag,

[SSP REAPER]

ando you may have to shave your on off pin to get past 20 in your emag,

and if you need a comparison # for a shave on the pin... my Xmag sports a .700 pin
It has Xmod 1.8 and a shaved pin. Ropes as fast as a hopper will let it. Ask Frizzle Fry how mean it is it went off next to his head on Sunday lol

[Ando]

Well if all else fails, I'll rig my Geddon up to push 2k through a regular RT mag and see what happens

[SSP REAPER]

Well if all else fails, I'll rig my Geddon up to push 2k through a regular RT mag and see what happens

excellent