first off, thanks alot guys. I've really wanted to make an e-mag since long before they started makin' them at agd. this particular design can generate 11 lbs of force and barely consumes any wattage. it all fits in a benchmark double trigger frame. I think it shows that e-mag design can be taken further than wjat the stock design is, and still be feasible to produce.





this gun is actually fairly old. I did the paintjob and the design about 5 years ago, so it's a little rough around the edges.



it of course has a Doc nickel barrel adapter so it uses cocker barrels.



this shows the on/off switch and the indicator light of the morlock. it the light can be seen through a small polycarbonate "window". this protects it, without losing any light intensity.




this shows an old idea I had. a small aluminum shroud
that covers the back of the valve. it's probably the only thing I've ever made that was just for "looks". I copied the AGD logo and reduced it. then transfered it to blank decal paper. it is then put on before the clearcoat.

the total cost wasn't too bad. I already had the cocker parts and the rest was about $200