Palmer's say YES to doing Twist lock barrels!

[BigTrucker]

When was the last time you talked to them. BTW, I'm splattttttt on MCB

On the 13th at POG day

[nobloodloss]

Been a while now, hasn't?

[mustangii]

Talked to Lori Thur, or Fri. she said the are almost completd the machining. since mine are brass unported, should be this week. If they are ported, nickel plated or black will take more time.
edm

[Craig Palmer]

All barrels that have been ordered have been machined. We should be putting the final touches on them tomarrow. Some will ship May 8th.

[nobloodloss]

All barrels that have been ordered have been machined. We should be putting the final touches on them tomarrow. Some will ship May 8th.

Awesome! That's today!!!

[questionful]

Can these be sold on an individual basis from now on?

[marked74]

Can these be sold on an individual basis from now on?

This would be awesome since I found this thread too late!

[nobloodloss]

Can these be sold on an individual basis from now on?

Sorry. This was a mass pre order.
You'll have to start the whole thing over again on yer own self.
Better late than sorry, I always say

[BigTrucker]

Can these be sold on an individual basis from now on?

If you want one give them a call. I do recall Lori telling me that they made a small number of collers to make up to 20 some thing total. After that they are gone. Unless you can get another mass pre-order going.

[Craig Palmer]

I made around 40 blanks.. The machine is still setup, so NOW is the time to order. By May 16th the machine will be running another job. After the 16th some 14" blanks will be in stock. We can cut them down or vent them as orders require.


I put up an old picture. We will put up a new pic sometime next week.

PPS AGD barrel


BTW... you might want to order it before Lori gets a chance to increase the price on Monday.

[questionful]

I made around 40 blanks.. The machine is still setup, so NOW is the time to order. By May 16th the machine will be running another job. After the 16th some 14" blanks will be in stock. We can cut them down or vent them as orders require.


I put up an old picture. We will put up a new pic sometime next week.

PPS AGD barrel


BTW... you might want to order it before Lori gets a chance to increase the price on Monday.

Cool! I will eventually get one of these. BTW, if I want a straight bore (non-elliptical), does the price change and do I just email?

[Craig Palmer]

Just request that in the comments section... Price is the same.

[nobloodloss]

Cool! I will eventually get one of these. BTW, if I want a straight bore (non-elliptical), does the price change and do I just email?

Why not the eliptical bore? That's like a turbo in the barrel.