Ego/Etek Mag conversion how to

[kcombs9]

what size threads are the barbs for the ram? I want to put my inlet on like yours.

[hill160881]

10/32 :)

[kcombs9]

Really? Thought it was smaller.

For the same size as the one In the back or for what you used?

10/32 is hugh

[kcombs9]

Well its not as hugh as I thought your right hill thanks!

[hill160881]

[mr_corean]

What size hose did you use for the noid?

[Automag ReTro]

http://palmer-pursuit.com/cart/index.php?main_page=product_info&cPath=1_16&products_id=73

That's the stuff.

[BenoitOWN]

What is the required crimp tool is we want to do it without plyers? One that not too pricy :P
Can we use the stock wire with the board instead of using a extension? I have them long enoufh already :)

[OneSelfLost]

Don't know much about the Ego's.. Are those the same plugs used for the E-mag solenoid? If not, would you happen to know the part number?

[BenoitOWN]

Suceeded to instal the plug :)
After I get a longuer screw and ram hole for q.e.v I will only have tubing and fine tuning left

[flood152]

So I have installed the crimps on the solenoid wire...is there an easy way to tell which side of the plug the black and red wires are supposed to go into?

[captian pinky]

it doesn't matter either way will work

[flood152]

Thanks man...It's great to have such an old thread still be so helpful.

[flood152]

So I'm about finished and I'm having some problems getting the ram to trip the sear. I've cleared out plenty of room in the frame to give the ram ample room away from the sear and it struggles to trip the sear. Out of twenty trigger pulls I'd say it fires one time. I have an xvalve and an evalve with the same results. I also have a .712 and .750 pin and same results with both. Any ideas or advice? Thanks

[hill160881]

Turn up the pressure a bit on the LPR.