Need some feedback on what kind of frame you would like to see me manufacture.

[mpsd]

The air fittings came in today so I can get back to work...

I'm really excited about this frame.

[keiko_819]

I'm really excited about this frame.

+ 1...

[sQuidvision]

i am pumped to see how this turns out... i might have to sell my chimera to buy one of these :)

[BTAutoMag]

Any news here? A sketch, maybe?

could you get a blurry picture of what you have so far. maybe walking in the woods of Louisiana?

I'M VERY EXCITE!

[luke]

[luke]

[Arstron]

For bearing maybe http://www.bocabearings.com/

[luke]

[OPBN]

Boing!

[Spider-TW]

My first pneu setup had the trigger rod just above center of my bottom finger. The lack of leverage on the top finger wasn't so noticeable, but the difference between the top and bottom was. That was with less than 1/2 of the msv-2 lever. With one finger you should be good, especially if you use a full MSV lever.

Just out of curiosity, would this single trigger have a ball bearing?

[mpsd]

Are you planning to mill the pockets for the trigger switch and MPA-3 as well so that one can easily assemble it with no need to do extra modifications?

[luke]

Are you planning to mill the pockets for the trigger switch and MPA-3 as well so that one can easily assemble it with no need to do extra modifications?

[BTAutoMag]

do we have a ballpark price yet?

[luke]

do we have a ballpark price yet?

[BTAutoMag]

i did say ballbark