Need some feedback on what kind of frame you would like to see me manufacture.

[mpsd]

[luke]

i did say ballbark

[Arstron]

While reading this I had a thought that crossed my mind, I am not sure how possible it would be or how economical, im just throwing out there. I also realize that simpler is usually better and im sure it is in this situation, but I figured id throw this out there anyway.

The original Dangerous Power Fusion has screw in LPR that also alows higher pressure to pass through it. The part of the LPR that screws into the body of the fusion is 1 1/2" long and 5/8 dia, the part that sticks outside the body is 7/16" deep and 3/4" dia. What I was thinking was a gas through foregrip design that could accept one of these lpr's in the bottom. I got a new program for the sign shop and needed the practice so below is a picture of roughly what I was thinking. Since a new regulator came in the parts kit and in their "hyper color kit" I know there has to be lots of unused LPR out there for it, I have 3 full working extras and a couple without any parts in them.

http://www.fusionowners.org/magforegrip.jpg

The top piece was an afterthought, it is a vertical asa that would go with it. The red is for HP, the yellow LP, green are orings, blue are fittings, brown is the foregrip and grey is the asa. Everything on the bottom is a recreation of the fusion lpr.

... I think I have to much time on my hands...

[mpsd]

Are we there yet?

[luke]

With what free time?

Have not even had a free second to even think about this project with the fund raiser stuff going on.

[mpsd]

With what free time?

Have not even had a free second to even think about this project with the fund raiser stuff going on.

Fair enough. But if you come up with this after the first week of October, you will have to hold one for me up to February so I can bring it with me next time I'll go to the US next year. I was really hoping to take one on this next trip...

[BTAutoMag]

With what free time?

Have not even had a free second to even think about this project with the fund raiser stuff going on.

do you have free time now?

[luke]

Got my brain back into this project finally, gotta make some changes in the original design and concept just to get this out, more info as it progresses.

I'm looking probably about a week and a half to get back to designing.

[BTAutoMag]

w00t, still trying to save up

[keiko_819]

count me in...im itchin to build me a new pump..

[robnix]

Got my brain back into this project finally, gotta make some changes in the original design and concept just to get this out, more info as it progresses.

I'm looking probably about a week and a half to get back to designing.

Looks like I came back at just the right time. Looking forward to your work, count me in.

[BTAutoMag]

I went through and re-read this thread.... (i rhymed ) and every time i get a sense of where its going I loose myself again...

So what I have gathered:

-It will be switchable from single to 2x trigger
-It will be a pneu-frame. can it be used as a mech?
-It will not be compatable with 45 grips. will it be a 45 frame? do we get panels with it?
-I am becoming very annoying.

did I miss anything? what do we have set in stone as of yet?

[luke]

Got my brain back into this project finally, gotta make some changes in the original design and concept just to get this out, more info as it progresses.

[BTAutoMag]

so the only thing set in stone is me being annoying

[OPBN]

so the only thing set in stone is me being annoying

First step in recovery is admitting you have a problem.